See Android

Configure wireless network (eduroam)

INTRODUCTION

This manual describes how you can configure a mobile phone with the operating system Android to use the eduroam network of the UT.

BEFORE YOU START

  • Make sure that before you configure the eduroam again, to "forget" the network first. 
  • The manual has been written for an Android phone. The steps are almost identical for other mobile phones with Android or other versions of Android. There is a possibility that the screenshots will differ.
  • This manual uses a consistent style of writing: references to text and buttons on screens are printed in italics, information that you have to enter yourself is printed in bold.  
  • Check if your password is still valid when you’re unable to connect after you’ve configured eduroam.

CONFIGURING EDUROAM

  • Go to Settings, Wi-Fi.
  • Select eduroam.
  • At EAP method, select TTLS.
  • Select MSCHAPV2 at Phase 2 authentication.
  • Select Use system certificates at CA certificate. If this is unavailable, select Do not validate 
  • Fill in utwente.nl at domain
  • enter your student number followed by @utwente.nl (e.g. s0123456@utwente.nl) for employees enter your (UT) e-mail address in the Identity field. 
  • If required fill in anonymous@utwente.nl at anonymous identity
  • Enter your password.
  • Tap on Connect.
  • You’re now connected with eduroam.